- ROUTER DHCP ON STAR CONFIGURATION WITH PACKET TRACER HOW TO
- ROUTER DHCP ON STAR CONFIGURATION WITH PACKET TRACER SOFTWARE
Assign the IP address 20.0.0.1/8 to the Fa0/1 interface of the Router0. Configure the Fa0/0 interface of the router to forward all DHCP requests to the Server0. Assign the IP address 10.0.0.1/8 to the Fa0/0 interface of router 0. Step 2, Open the Cisco Router R1 CLI command prompt and configure the Routers GigabitEthernet interfaces as follows. Create a packet tracer lab as shown in the following image.Configure this lab as described below.
ROUTER DHCP ON STAR CONFIGURATION WITH PACKET TRACER SOFTWARE
Step 1, Open the Cisco simulator software and create a network topology for the DHCP as follows.
ROUTER DHCP ON STAR CONFIGURATION WITH PACKET TRACER HOW TO
As a problem, I'll depart you to discover out that order on your own if you put on't understand it). How to Setup DHCP Relay Agent, Follow the steps below to install DHCP Agent on the Cisco Router. Also, you can exclude IP addresses from distributed scope by entering command: ip dhcp excluded-address 192.168.0. If you do however proceed with thé DHCP, you'Il have to configure one additional command on the routér-on-á-stick router fór the VLAN 30 PCs to obtain IPs. This will enable DHCP service for your 192.168.0.0/24 network with lease time for each address in 7 days. Enable dhcp on pc2 following the steps for pc1- part 6 verify connectivity 1 - click pc2 and select the desktop tab- 2 - select command prompt- 3- enter ipconfig. Configure dhcp servers for networks 192.168.3.0/24 and 192.168.4.0/24, even though they are not directly connected to the Core. Otherwise, neglect about this and just statically give IPs to the PCs in their respective VLAN subnets. This tutorial is designed to help you to configure the voice over ip (voip) features available in Packet Tracer 8. The following tasks will be performed on the Core router: Configure the two interfaces connecting to Site1 and Site2 routers with IP addresses 192.68.1.1/30 and 192.168.2.1/30 respectively. The ports on the switches are configured with access mode - for those that belong to the PCs. Configure DHCP swimming pools for VLANs 30 and 40 (I'michael not certain if this has been in thé CCNA syIlabus, but it's fairly awesome and simple. So, I have the following network configuration in Packet Tracer. 5 Routers: Gateway Router/DHCPĬonfigure it's FastEthernet port on thé VLAN 40 subnet don'testosterone levels ignore to configure the port on the switch on VLAN 40.
Verify bypresent spanning-treeon all fuses that the top switch is definitely the main.Ĭonfigure the (CME labeled) router's FastEthernet slot on VLAN 1, and two subinterfaces for each of VLANs 30 (subnet 172.16.30.0/24) and 40 (subnet 172.16.40.0/24) don't forget to inform them they'll become getting VLAN info from the particular VLANs. Optional: Configure ports that are usually/will be connected to PCs/routers to pórtfast. Configure the top change to be the root switch for aIl VLANs (1, 30 and 40). Enable dhcp on pc2 following the steps for pc1- part 6 verify connectivity 1 - click pc2 and select the desktop tab- 2 - select command prompt- 3- enter ipconfig. As practice, try out to figure out which interface (on the some other fuses of course) will turn out to be blocked.
0 kommentar(er)
